Port Forwarding - Gateway

Linksys RV0041

1. Open Your Web Browser (i.e. Internet Explorer, or Firefox etc…) 2. Type in your Router's IP Address in your browser's web address bar. (i.e. http://192.168.0.1). If you do not know your Router's IP Address follow these instructions below to find it: a. Click START (Windows Only) b. Click RUN c. Type in: “cmd” in the open field and click OK d. When the new window appears (black window) type “ipconfig” and press ENTER e. A list of numbers should appear in the window. The numbers that appear after Default Gateway will be the IP Address of your Router. f. Copy that number and type it in your web browser. (remember to use “http://” in front of the numbers) Press Enter.





3. In the login dialog box, enter your Username and Password. By default, the Username should be left blank and the Password is admin. Click OK to open your router's administration page.





4.Your router's administration page should look something like the image below. Click the Setup tab located in the horizontal navigation bar to open a new set of links below the Advanced Settings tab. On the new set of links, click on Forwarding.





5 .In the Port Range Forwarding section of the page, click on Service Management link to open the Service Management control panel.





6.The Service Management control panel is shown below.In the Service Name field, type what you want to call the device. For Example: "HRGatewayWeb". This will assign a name to the device whose web port you are opening. In the place Protocol field, check TCP. In the Port Range field, enter the Starting Port number in the left entry field, and the Ending Port number in the right entry field. It is prefered that you use port numbers 80 ~ 80 for your Web access. If you are currently using port 80 for another device, please use port 81 ~ 81 or another port protocol.



7. Click on Add to list. The Service Management control panel should now look like the image below. Click on Save Setting. Click on Exit.


8. Again, locate the Port Range Forwarding section of the page. In the Service drop down menu, select the HawkingTech service you just created.


9. In the IP Address field, enter your HawkingTech device IP Address. (How to Find your Local IP Address) Click Save Settings at the bottom of the page to save your changes. Unless you do this, your router will not be configured. Make sure that the Enabled checkbox is checked. Click on Add to list (in the Port Range Forwarding section of the page).


10. You should now see a port forwarding entry listed for Hawking. Click Save Settings at the bottom of the page to save your changes. Unless you do this, your router will not be configured. Congratulations! you've done it.